|
Page 14 of 26
Programming Preset Modes
The ds32a memorizes all Mode settings and can be programmed to power-up
according to your personal preferences and work style. There are two
power-up options:
- Most Recent Modes power-up: The ds32a simply powers up in the modes
last used.
- Preset Modes power-up: The ds32a always powers up in your preferred
mode settings.
Once the ds32a powers up you can, of course, change mode settings.
Programming simply establishes the initial power-un modes for your
convenience.
Most Recent Modes power-up
To set the ds32a to power up in the most recent mode settings, perform the following steps:
1. Turn on the ds32a by clicking the Power key.
2. Hold the Power key about 5 seconds until the Red LED (Low battery indicator) flashes, then Release.
All modes are memorized from last use (Amplify, Bell/Diaphragm, Noise
Rejection). Note that Most Recent Modes power-up defaults to a 2-minute
auto shutoff. However, auto shutoff time is extended another minute
when any key is clicked, up to a maximum of 5 minutes.
Preset Modes power-up
To set the ds32a to power up in specific modes, regardless of the mode
settings when it was last used, perform the following steps:
1. Turn on the ds32a by clicking the Power key.
2. Set all ds32a Modes to your preferences. These include:
Amplify/Acoustic mode
Bell/Diaphragm mode
Noise Rejection On/Off
3. Set the auto shutoff time - Click the Power key once for each minute
you’d like the ds32a to stay on before auto shutoff. Click twice for 2
minutes, 3 times for 3 minutes, etc. up to 5 clicks for 5 minutes. The
minimum setting is 2 minutes, the maximum is 5 minutes.
4. Hold the Power key for at least 10 seconds. After 5 seconds, the Red
LED (Low Battery indicator) will begin to flash slowly. Continue to
Hold. After 10 seconds, the Red LED will flash more quickly, indicating
that Preset Mode is programmed. Release the Power key. Settings are now
memorized. When performing the final step, ensure that you hold, and do
not click the key inadvertently, since this will increase your
programmed auto shutoff time.
To cancel Preset Modes power-up, simply follow the instructions for Most Recent Modes power-up.
|
![](/templates/thinklabs/images/2008_logo.jpg"){kind=logo}
Support and FAQs 
